The Diestco Manual Wheelchair Cover is a lightweight cover that is made from 400-denier nylon with a urethane backing that provides the highest level of protection for your wheelchair from weather and dust. It is easy to get on and off, simply slip the cover over your vehicle and pull the elastic down under your chassis. Pull the chord lock so that it is tight around the bottom.

The cover works great on lifts or for just storing outside. For extra security, when transporting your vehicle on the back of your car or van, tie down the bottom by hooking bungee-type cords (not included) through the bottom belt loops. This will reduce the amount of excess room under the cover and prevent the cover from billowing up at high speeds. If your cover is flapping excessively at high speeds, the life of the cover will be greatly reduced.

This is a Standard cover and you will need grommets with a draw cord and cord lock to tighten it. Depending on your vehicle, cover may not fit over wheels.

Features and Benefits:

NOTE: This wheelchair is not intended for highway use without a securing device (i.e. rope or bungee cords). We recommend reducing the excess room under the cover to prevent the cover from billowing up at high speeds. The life of the cover may be adversely impacted if your cover is flapping excessively at high speeds.

Slip the cover over your wheelchair and pull the elastic down under your chassis. Pull the cord lock to make sure that it is tight around the bottom. For enhanced security, when transporting your wheelchair on the back of your car or van, tie down the bottom by hooking bungee-type cords (not included) through the bottom belt loops.

Please note that this is a Standard cover; you will have grommets with a drawcord and cord lock to tighten. Depending on the size of your mobility device, this cover may not fit over the wheels.